Graduation

To qualify for the degree of Bachelor of Science in Engineering Technology, the student must satisfy University and College requirements, and obtain a 2.0 grade point average on all work completed, and obtain a minimum grade of “C-” in all engineering technology and mathematics courses used to satisfy degree requirements.

University General Education Program (42 hours)

See Graduation from the University link  for University General Education Program requirements. Note the following are specified by the department for this program:

College and Degree Requirements (7 or 8 hours)

• CHEM 1010 - Chemistry of Materials** Credit Hours: (3)
• CHEM 1011 - Chemistry of Materials Lab ** Credit Hours: (1)
• MATH 1730 - Pre-Calculus** Credit Hours: (4)

• or

• ENGR 1009 - Prep Math for Engineering Credit Hours: (3)

The Major (74-77 hours)

Typical 4-Year Engineering Technology Sequence

Total Hours Required for Graduation: 123-125

*Must satisfy University General Education Program Requirement

** Courses offered only online or both online and on-ground

Accelerated BS/MS Program

The Accelerated Bachelor’s to Master’s (ABM) program in Engineering Technology allows outstanding undergraduates to begin the coursework for the Master of Science (M S) in Engineering Technology during their undergraduate studies. Students are encouraged to begin planning to enter the ABM program early in their undergraduate career, in consultation with their academic advisor. Only in ABM programs, up to 12 hours of graduate coursework may be applied to both the undergraduate and graduate programs. However, any graduate coursework will not apply to undergraduate GPA.

To be eligible, students must have a minimum 3.25 grade point average and must have completed at least 75 credit hours of undergraduate coursework towards the B S in Engineering Technology. To apply, students must (1) complete an interview with the undergraduate academic coordinator, (2) request a letter of sponsorship from a program faculty member, and (3) submit a statement of interest to the Department of Engineering Technology. Qualified students will be admitted to the ABM program when they have no more than 34 credit hours remaining to complete the B S in Engineering Technology.

Undergraduate students who are selected into the program must maintain a minimum cumulative 3.25 GPA each semester until completion of the B S in Engineering Technology.  ABM undergraduates must also apply to the Graduate School for the ABM program, which allows them to take graduate courses as an undergraduate student. Working with the undergraduate and graduate academic coordinators, ABM undergraduates may register for and substitute graduate level courses for undergraduate electives or take and substitute.